Datamax Allegro 2 Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 115
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Getting Started
Allegro2 7
Paper/Ribbon This light is activated when:
Light: No label and/or ribbon is detected.
The Internal Rewinder (if installed) is not
rotating, (i.e., maximum rewind capacity has
been reached).
Ribbon For direct-thermal printing, (no ribbon), slide the
Switch: switch to the ‘off’ position. For thermal-transfer
printing, (ribbon installed), slide the switch to the
‘on’ position.
Darkness POT: This POT is used to fine adjust the print darkness
due to variations in different media’s and
printheads.
Note: Do not use this control for adjusting individual label printing
jobs, rather, use the software control with the ALT-P Print
Parameters Screen in the Internal Batch Mode (see Section 4),
or the proper command in RS-232 mode to vary darkness of
printing on a per-label-format basis.
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 114 115

Comentarios a estos manuales

Sin comentarios