Datamax I-Class Manual del operador descargar pdf (Pagina 98)

88 I-Class

General Resolutions (continued)

If experiencing this

problem…

Try this solution…

Nothing happens when

printing from your

software program:

• Ensure that the printer is at READY.

• Send the job again while observing the Ready Indicator

(see Section 4.1.1.) – If the indicator does not flash, check

the printer and host for protocol and port settings.

• Ensure the interface cable meets the requirements found in

Section 3.1.1.

Poor print quality:

• The printhead may need cleaning – See Section 5.6.1.

• Adjust the Heat and Print Speed settings via the menu or by

host commands – See Section 4.2.3.

• T he media/ribbon combination may not be compatible –

See Section 7.2.2.

• The Leveling Cam may be incorrectly adjusted – See

Section 5.4.1.

• The Platen may be dirty or worn – See Section 5.6.2.

• The Printhead Burn Line may need adjusting – See Section

5.4.2.

Skips labels when

printing:

• Calibration may be needed – See Section 3.5.

• The Media Sensor may be out of position – Readjust the

position; see Section 3.3.

• The format may be within 1/8 inch (3 mm) of the label’s

edge – Try reducing or moving the format slightly.

Unable to print rotated

text:

The characters may be formatted outside the label dimensions

– Ensure the row/column values provide enough room for the

height of the characters or bar code to be printed. See the

Class Series 2 Programmer’s Manual.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 131 132

Sin comentarios

Datamax I-Class Manual del operador Pagina 98